Technical description of operation stop valve

The movement form of the valve stem of the globe valve has a lifting rod type (the valve stem is lifted and lowered, the hand wheel does not move up and down), and there is also a lifting and rotating rod type (the hand wheel and the valve stem rotate together and the nut is set on the valve body). The globe valve is only suitable for full opening and full closing, and adjustment and throttling are not allowed. The globe valve is a forced-sealed valve, so when the valve is closed, pressure must be applied to the valve flap to force the sealing surface to leak. When the medium enters the valve six from below the valve flap, the resistance to be overcome by the operating force is the friction force of the valve stem and the packing and the thrust generated by the pressure of the medium. The force of closing the valve is greater than the force of opening the valve, so the valve The diameter of the rod is large, otherwise the valve stem will be bent. In recent years, after the appearance of the self-sealing valve, the medium flow direction of the globe valve is changed into the valve chamber from above the valve flap. At this time, under the action of the medium pressure, the force of closing the valve is small, and the force of opening the valve is large, the valve stem is The diameter can be reduced accordingly. At the same time, this type of valve is also tight under the action of the medium. China's valve "three-way" has stipulated that the flow of the stop valve will be from top to bottom.

When the globe valve is opened, the opening height of the valve flap is 25% to 30% of the nominal diameter, and the flow rate has reached the maximum, indicating that the valve has reached the fully open position.